1-800-352-9050      
        

 

 

 

GLOC-KUT 3049A

A Heavy Duty Synthetic Coolant

 

Description                                                                                                                        Product Data

GLOC-KUT 3049A is a heavy duty cutting fluid with excellent hard water stability.  GLOC-KUT 3049A combines the lubricity of extreme pressure cutting oils with the superior cooling, wetting properties and anti-weld properties of heavy fortified soluble oils. GLOC-KUT 3049A contains no mineral oils, nitrites, phenols, chromates, chlorine or sulphur. GLOC-KUT 3049A contains a unique compound to provide maximum lubricity for all machining and grinding operations. GLOC-KUT 3049A has superior lubricity and extreme pressure (EP), which allows for use on aluminum.

 

KEY PERFORMANCE QUALITIES

 

Excellent chip/fines settling properties                                                                                

Effective cooling with high lubricity  

Unique tool / wheel performance            extended tool life

Exceptionally Clean

High degree of operator acceptance

Excellent foam control

Transparent (to see) in work place

Good Bio-stability

No nitrites or phenols

 

TYPICAL APPLICATIONS

GLOC-KUT 3049A was developed for any type of grinding operation from ferrous to non-ferrous materials. GLOC-Kut 3049A is recommended for machining operations such as broaching, milling, turning, boring, drilling and other machining operations. GLOC-KUT 3049A is equally recommended for large central systems as well as for individual sumps.

                                                                                             

TYPICAL PROPERTIES:

 

Appearance Concentrate:

Clear

Hard Water Solubility

Good

Foam Height

Low

Specific Gravity at 60°F

1.039

Density LBS/GAL

8.65

Odor

Characteristic

PH @ 10% Vol.

8.70-9.70

Odor

Characteristic

 

 

 

 

To obtain samples please contact our customer service representative.

 

 

 

CONCENTRATION CONTROL

 Please refer to the conversion chart

 

CONCENTRATION

 

3%

(1:33)

 

5%

(1:20)

 

6%

(1:14)

 

10%

(1:10)

REFRACTOMETER

READING

1.5

2.5

3.0

5.0

 

Refractometer concentration charts have been prepared in dilutions using de-ionized (DI) or distilled water.  Different types of water can have a significant effect on refractometer readings of coolant samples.  It may be necessary to prepare your own chart using plant water.

 

RECOMMENDED DILUTIONS

General machining:                                                                               20:1            to            40:1

Tapping and threading                                                                         15:1             to            25:1

Broaching and other severe operations:                                                  5:1             to            15:1

Grinding                                                                                              20:1             to            30:1

 

Storage/Handling/Disposability

No health or safety hazards exists when GLOC-KUT 3049A metalworking fluids are stored, used and disposed of in accordance with instructions given on the Material Safety Data Sheet for this product.

 
  
   back to Private Label