1-800-352-9050      
        

 

 

 

GLOC-KUT EP

Heavy Duty Bio-Stable Micro-Emulsion Coolant

 

Description                                                                                                                            Product Data

GLOC-KUT EP is a Heavy-Duty Semi-Synthetic Micro Emulsion Concentrate with excellent hard water stability.  GLOC-KUT EP was develop with specialty additives and raw materials combined together to create our finest series of cutting and grinding fluids. GLOC-KUT EP contains no nitrites, phenols, chromates, active sulphur or phosphorous. GLOC-KUT EP has a Bio-Stable additives and anti-oxidants combined with special lubricity agents and base oils to naturally resist biological degradation. GLOC-KUT EP has superior lubricity and extreme pressure (EP), which can be use on aluminum.

 

KEY PERFORMANCE QUALITIES

 

High performance all purpose coolant

Excellent chip/fines settling properties                                                                                

Effective cooling with high lubricity  

Unique tool / wheel performance            extended tool life

Excellent rust protection

High degree of operator acceptance

Transparent (to see) in work place

Good Bio-stability and superior resistance to rancidity

 

TYPICAL APPLICATIONS

 

GLOC-KUT EP was developed for any type of ferrous to non-ferrous metals such as stainless, nickel, aluminum, vanadium, bronze, inconel, cast as well as nodular iron and tool steels such as FX, P20, M1, M2, H13 and C4130. GLOC-KUT EP covers a multitude of usually difficult machining and grinding operations. GLOC-KUT EP is equally recommended for large central systems as well as for individual sumps. GLOC KUT EP may also be used for machining of most plastics and glass.                                                  


TYPICAL PROPERTIES:

 

Appearance Concentrate:

Clear Blue Liquid

Hard Water Solubility

Good

API Gravity, 60*F

9.0

Specific Gravity at 60°F

1.01

Density LBS/GAL

8.65

Flash Point, COC, F

None

pH @ 5 % Vol. In tap water

9.4

Odor

Mild

 

 

 

 

To obtain samples please contact our customer service representative.

 

 

 

CONCENTRATION CONTROL

 

Please refer to the conversion chart

 

CONCENTRATION

 

3%

(1:33)

 

5%

(1:20)

 

7%

(1:15)

 

10%

(1:10)

REFRACTOMETER

READING

2.2

3.8

5.2

7.8

 

Refractometer concentration charts have been prepared in dilutions using de-ionized (DI) or distilled water.  Different types of water can have a significant effect on refractometer readings of coolant samples.  It may be necessary to prepare your own chart using plant water.

 

RECOMMENDED DILUTIONS

General Machining:                                                                                20:1            to            40:1

Milling, Drilling & Turning:                                                                    10:1             to            20:1

Tapping, Threading, Reaming & Boring                                                  10:1            to            15:1

Aluminum & Stainless                                                                            10:1             to           20:1

Grinding – ID, OD & Center less                                                           20:1             to           30:1

Blanchard: Segmented wheel grinding                                                     25:1             to           35:1

Sawing                                                                                                  10:1             to           20:1    

Storage/Handling/Disposability

No health or safety hazards exists when GLOC-KUT EP metalworking fluids are stored, used and disposed of in accordance with instructions given on the Material Safety Data Sheet for this product.

 

  back to Private Label