SOLUTION 575 BRAKE PARTS CLEANER

SOLUTION 575 BRAKE PARTS CLEANER

Performance:

NON-FLAMMABLE ¨ Evaporates Quickly And Completely ¨ Helps Degrease And Remove Brake Fluid, Rust, And Other Contaminants From Brake Linings And Other Brake Parts

SOLUTION 575 BRAKE PARTS CLEANER helps clean and remove contaminants from brake parts, does not require disassembly of the brake unit. Quick-drying formula that does not leave a residue.

Properties:

Flash point (liquid) none

% Non-volatiles none

Propellant Carbon dioxide

Boiling point 105° F

Specific gravity 1.5

Vapor density Heavier than air

Evaporation rate Slower than ether

Solubility in water Nil

APPLICATIONS:

Use to clean brake parts (disc and drum brakes, brake linings, cylinders, drums, and springs), clutches, CV joints, tools, and wheel bearing assemblies.

DIRECTIONS: Always refer to the Material Safety Data Sheet and product label for safety information. Hold can upright. Do not get product on plastic, rubber, painted, waxed, or similar finished surfaces; severe damage may result. Protect these surfaces from over-spray and immediately use water to rinse off product that may contact these surfaces during application.

Lightly wet down all dusts and surfaces to be cleaned by spraying short bursts from a distance of about 18 to 24 inches.
After surfaces have been wetted, continue spraying at a distance of about 12 to 18 inches to flush contaminants from surface.

After spraying parts thoroughly, allow to air dry (or wipe with a soft, clean cloth). If deposits are heavy, repeat application.

back